Skip to content
Christmas gifts
FREE UK DELIVERY OVER £40 · NEXT DAY IF YOU ORDER BY 3.30PMFREE UK DELIVERY OVER £40
SIGN IN
BAG (0)
Silver-haired man in a navy suit sliding a half Windsor knot in a navy and white pin-dot silk tie up to his collar while holding the narrow end

Knots & folds

How to tie a half Windsor knot

Fuller than a four-in-hand and less work than a Windsor. The half Windsor is the knot for a semi-spread collar and a medium silk tie.

5 min readUpdated 8 November 20268 steps

Start the steps

At a glance

to a half Windsor
8 steps
the collar it belongs with
Semi-spread
the tie that suits it best
Medium silk
most of our silk ties: length to spare
148cm

The half Windsor is a neat triangle of middling size. It sits squarely in a semi-spread collar, holds its shape through a long day, and gives a lighter silk tie more presence than a four-in-hand would. If you learn one knot after the four-in-hand, make it this one.

It takes its name from wrapping the neck loop on one side only; the full Windsor wraps both. The result looks almost as symmetrical, uses less of the tie, and suits more collars and more men.

Tying the half Windsor

Button your collar and turn it up. Left and right below are your own, so the mirror will show them reversed. Keep each pass snug rather than tight until the last step.

  1. Hang the tie round your neck, seams inward, with the wide end on your right and the tip of the narrow end about a hand and a half above your waistband.

  2. Cross the wide end over the narrow end, from right to left.

  3. Take the wide end behind the narrow end and back to the right.

  4. Bring it up on the right and pass it down through the neck loop from the front, so that it comes out on your left.

  5. Cross it over the front from left to right, making a band across the knot.

  6. Bring the wide end up behind the knot and out through the neck loop.

  7. Pass it down through the band at the front.

  8. Hold the narrow end and slide the knot up to your collar, then turn the collar down.

The dimple and the finish

Make the dimple as you tighten, not afterwards: press a forefinger into the blade just below the knot, pinch the edges in with thumb and middle finger, and hold the crease while you slide the knot up.

Then check the length. The tip should just touch your waistband, and the narrow end should sit out of sight in the keeper loop on the back of the blade. If the tip is short, start again with the narrow end shorter; if it is long, leave the narrow end longer.

When to wear it

The half Windsor belongs with a semi-spread collar — the everyday business collar — and a tie of medium or light silk. It is the safe choice for an interview, a day of meetings or a wedding guest’s tie, and it sits neatly in the opening of a waistcoat.

Point collarFour-in-handSemi-spread collarHalf WindsorCutaway collarWindsor
The half Windsor belongs with the semi-spread collar.

With a narrow point collar it can look crowded; tie a four-in-hand instead. With a wide cutaway it may look small, and that is the Windsor’s job. At a funeral, a half Windsor in a dark, plain tie is quietly correct — see what to wear to a funeral.

The tie makes the knot

The same knot comes out larger in a thick tie and smaller in a thin one, so let the cloth guide you.

  • Knitted or heavy wool

    In a half Windsor
    Bulky and stiff
    Better choice
    Four-in-hand
  • Heavy woven silk

    In a half Windsor
    Large
    Better choice
    Half Windsor with a wide collar; otherwise a four-in-hand
  • Medium silk, 8cm

    In a half Windsor
    Just right
    Better choice
    Half Windsor
  • Light silk

    In a half Windsor
    Neat and compact
    Better choice
    Half Windsor, or a Windsor in a cutaway collar
  • Slim silk, 5.5–6.5cm

    In a half Windsor
    Small, with a little more body
    Better choice
    Half Windsor or four-in-hand

Most of our silk ties are 8cm wide and 148cm long, which leaves plenty of length for a half Windsor on most men. Plain silk ties show the shape of the knot best; striped ties and neat patterns keep it businesslike. A pattern forgives a slightly uneven knot; a plain tie shows every fault, so practise on a pattern.

Putting it right

  • Leaning to one side — the band across the front was pulled tighter at one end. Untie it and keep the tension even.
  • Tip too short — the wide end started too high. Start again with the narrow end shorter.
  • Knot too big for the collar — the tie is too thick for this knot. Tie a four-in-hand.
  • Untidy after an hour — the knot was left too loose. Draw it up firmly at the end, holding the narrow end.

Untie it fully after every wear — never pull the narrow end back through the knot. Undo it in the reverse of the order you tied it, and let the tie rest a day before you wear it again.

The kit

Ties for the office

The half Windsor’s home: a medium silk about 8cm wide, with a semi-spread collar.

All silk ties —

Questions

Anything else? Call us on +44 (0)20 3232 5900

  • What is the difference between a half Windsor and a Windsor?

    The half Windsor wraps the neck loop on one side; the Windsor wraps both. The Windsor is larger and broader, and uses more of the tie.

  • Is a half Windsor right for a job interview?

    Yes. It is neat, symmetrical and quietly formal — the right knot for a semi-spread collar and a plain or lightly patterned tie.

  • Can I tie a half Windsor with a slim tie?

    Yes, and it gives a slim tie a little more body. With a narrow collar, a four-in-hand usually looks better in proportion.

  • Why is my half Windsor lopsided?

    Uneven tension, usually in the band across the front. Keep every pass snug, and tighten only at the end.